VMC with integrated control, machine, tooling and workholding.

For cost effective, high-mix, low-volume work

Designed to be easy to learn and use, the TRAK LPM incorporates technologies to markedly reduce the changeover times that plague high-mix, low-volume shops. It is the only VMC to integrate the machine, control, fixturing, and tool offset measurements into one complete system.

This means that it doesn't require expensive probing systems that consume spindle time to measure offsets. It also means that it doesn't require a room full of special fixture to facilitate quick changeovers.

Other manufacturers install a general-purpose production CNC on a machine, load in a few parameters and leave it at that. The ProtoTRAK PMX goes beyond to reduce your work in setup.